Low-Speed Signaling: A signaling system has a bit rate of only IO bits/s and must operate over a…

Need your ASSIGNMENT done? Use our paper writing service to score better and meet your deadline.


Order a Similar Paper HERE Order a Different Paper HERE

Low-Speed Signaling: A signaling system has a bit rate of only IO bits/s and must operate over a single 10-m, 50-ohm transmission line ( a transmitter reference cannot be sent along with the data). The system should dissipate as little power as possible while providing adequate margins under worst case noise assumptions. Using the noise parameters for the LSC signaling system in Tables 7-4 and 7-5, compare the power requirements of a series terminated voltage-mode signaling system with a pulsed, parallel-terminated, bipolar current-mode signaling system that has a pulse width of 5 ns. For the series-terminated, voltage-mode signaling system (which cannot cancel supply noise), assume the power-supply noise is 500 Mv

Tables 7-4

Tables 7-5