Make a working drawing of the cross slide shown in Fig. 8-120. Scale 1:1. The following…

Need your ASSIGNMENT done? Use our paper writing service to score better and meet your deadline.


Order a Similar Paper Order a Different Paper

Make a working drawing of the cross slide shown in Fig. 8-120. Scale 1:1. The following information is to be added to the drawing:

• The dovetail slot is to have a maximum roughness value of 3.2 µm and a machining allowance of 2mm.

• The ends of the shaft support are to have maximum and minimum roughness values of 1.6 and 0.8 µm and a machining allowance of 2 mm.

• The hole is to have an H8 tolerance.